|
|
| Subject: | Enable full command log in zencommand? |
| Author: | Joan |
| Posted: | 2015-09-21 05:54 |
I usually call the command "zencommand -v10 --device=deviceid --showfullcommand" when debugging issues with a specific command. That works fine on single runs, but I would like to have a full debug of zencommand for some time (I want to know if some commands are properly called)
Is there any way to enable this
| Subject: | check the config in $ZENHOME |
| Author: | Andrew Kirch |
| Posted: | 2015-09-23 18:45 |
check the config in $ZENHOME/etc/zencommand. Note that this is likely to fill the disk FAST
Andrew Kirch
akirch@gvit.com
Need Zenoss support, consulting or custom development Look no further. Email or PM me!
Ready for Distributed Topology (collectors) for Zenoss 5 Coming May 1st from GoVanguard
| Subject: | Thanks a lot |
| Author: | Joan |
| Posted: | 2015-09-28 04:30 |
Thanks a lot
| < |
Previous SNMP trap mapping issue |
Next Change hostname of zenoss 5 host server |
> |