|
|
| Subject: | Monitoring LAN drive |
| Author: | [Not Specified] |
| Posted: | 2014-07-11 05:06 |
Hi,
can Zenoss check the capacity of connect LAN drive from a windows server
Thanks in advance!
| Subject: | Athanast: |
| Author: | Andrew Kirch |
| Posted: | 2014-07-11 13:02 |
Athanast:
Not sure how the drive is connecting but if it's mounted on the windows server we should see it when we model the server. If it's visible from Zenoss itself (via commandline SMB, commandline curl/wget, or similar, you can write a command notification for it as a specific device, you might also check to see if it supports SNMP).
To provide more specific help I'd need to know what make/model the LAN drive is
Andrew Kirch
akirch@gvit.com
Need Zenoss support, consulting or custom development Look no further. Email or PM me!
Ready for Distributed Topology (collectors) for Zenoss 5 Coming May 1st from GoVanguard
| Subject: | My question is where is the |
| Author: | Andrew Kirch |
| Posted: | 2014-07-14 13:41 |
My question is where is the drive/volume located Is this on a windows server, or
My advice would differ if this is a buffalo terastation vs being a windows server.
Andrew Kirch
akirch@gvit.com
Need Zenoss support, consulting or custom development Look no further. Email or PM me!
Ready for Distributed Topology (collectors) for Zenoss 5 Coming May 1st from GoVanguard
| < |
Previous Set CPU Load Threshold based on number of CPUs |
Next Monitor Windows Server CPU,memory and hard disk capacity |
> |